Re: stepper motor and swivel?

To: Brent Earl <grouchy@eagle.ais.net>
Subject: Re: stepper motor and swivel?
From: Mehmet T Avcioglu <mta59066@pegasus.cc.ucf.edu>
Date: Wed, 24 Jan 1996 16:22:04 -0500 (EST)
cc: linux-connectix@crynwr.com
From pegasus.cc.ucf.edu!mta59066 Wed Jan 24 16: 45:52 1996
In-Reply-To: <m0tf7aJ-000DcBC@eagle.ais.net>

I have a cgi-bin program that controls two steppers independently over 
the net. If you like I can post the schematics and the source for the 
program. 

P.S. It uses the parrallel port so with QCam, you need two of them.

--------------------------------------------------------------------------
  Mehmet Tolga Avcioglu				     m.avcioglu@ieee.org
  http://pegasus.cc.ucf.edu/~mta59066/	     mta59066@pegasus.cc.ucf.edu
--------------------------------------------------------------------------

On Wed, 24 Jan 1996, Brent Earl wrote:

> Okay, who is going to provide the schematics and instructions
> to build the stepper motor and swivel to rotate the camera
> from directional widgets on the x[fm]qcam display?
> 
> Any failed robotics wanna-bes out there?
> 
> -Brent
>

References:

stepper motor and swivel?

From: grouchy@eagle.ais.net (Brent Earl)