Re: Microcontrollers, robots etc... w/qcam

• To: fugue@dura.spc.uchicago.edu
• Subject: Re: Microcontrollers, robots etc... w/qcam
• From: Brian Scearce <bls@best.com>
• Date: Thu, 12 Jun 1997 07:41:08 -0700 (PDT)
• Cc: mahesh@gussolomon.ius.cs.cmu.edu, quickcam-drivers@crynwr.com
• Delivered-To: quickcam-drivers@crynwr.com
• In-Reply-To: <199706121416.JAA19195@dura.spc.uchicago.edu> from "fugue@dura.spc.uchicago.edu" at "Jun 12, 97 09:16:33 am"

Mark:
> I've been thinking about doing this myself.  The solution I came up with
> would be two servos, one mounted on the other, with the camera mounted on
> the second servo.

If anyone else is planning on doing this, avoid the mistake I made.
The servo attached to the camera should be the up-down axis; the
servo attached to the tripod should be the left-right axis.  If
you can't see why this is so, you're in the same boat I was when
I started.

Brian

• Re: Microcontrollers, robots etc... w/qcam
• From: fugue@dura.spc.uchicago.edu

• Prev: Re: e: Microcontrollers, robots etc... w/qcam
• Next: Re: e: Microcontrollers, robots etc... w/qcam
• Index: Mail Index
• Thread: Mail Thread Index